Uni Knee Resurfacing (Encore EPIK®)

Overview

Unlike total knee replacement surgery, this less-invasive procedure replaces only the damaged or arthritic parts of the knee. The Encore Medical EPIK® unicompartmental knee procedure uses specially-designed metal and plastic implants.

Incision Made

The surgeon creates a small incision in the knee to access the joint. Damaged, arthritic portions of the femur are removed.

Damaged Meniscus Removed

Parts of the damaged meniscus are also removed. Some bone is removed from the tibia to make room for the new metal tibial component.

Femoral Condyle Prepared

A small amount of bone is removed from the damaged, arthritic femoral condyle. The end of the femur is reshaped to fit the metal femoral component.

Tibial Component Attached

The surgeon cuts a groove into the tibia surface. Cement is applied to the tibia. The metal tibial component is then pressed into place.

Femoral Component Attached

The prepared end of the femur is filled with bone cement, and the metal femoral component is pressed into place.

Plastic Implant Inserted

A plastic implant is inserted between the metal femoral and tibial implants.

End of Procedure

The new parts of the knee joint are tested by flexing and extending the knee through its range of motion.

Please be aware that this information is provided to supplement the care provided by your physician. It is neither intended nor implied to be a substitute for professional medical advice. CALL YOUR HEALTHCARE PROVIDER IMMEDIATELY IF YOU THINK YOU MAY HAVE A MEDICAL EMERGENCY. Always seek the advice of your physician or other qualified health provider prior to starting any new treatment or with any questions you may have regarding a medical condition.